The Raidmax power supply is now installed along with the front bezel, and the case is starting to take shape! In fact, the only thing left for us to do is mount our Lightstrips, add the drive cables, and wire everything to our inverter bus!

For the drive cables, I chose to use some clear mesh rounded cables supplied to me by my buddy William over at Heatsink Factory. I figured they would add a nice touch to offset all of the lights in the case better than plain blue cables would, and I was right.

I decided to locate the Lightstrips in the following areas to maximize their effectiveness:

• 2 blues on the bottom of the case
• 2 reds running up the sides of the front bezel
• 1 green on the back left of the case (beside the exhaust fan)
• 1 green wrapped directly around the system RAM module

Yes, you read that right. I wrapped one Lightstrip directly around the RAM module heat spreader! Now that the Lightstrips are installed, all that's left to do is attach all of our fans and Lightstrips to the inverter bus, and admire our work!

Go to the next page to see the finished case gallery.