When applying the adhesive, it is best to apply the adhesive to the RAMcooler first, and then place the RAMcooler on top of the RAM chip. This tends to yield the best quality job and least amount of mess.

Try not to glue the coolers on with more than is absolutely necessary. Even though Arctic Alumina Adhesive does not conduct electricity, you want to do a quality job of gluing the RAMcoolers on so your project comes out looking as good as it performs. After you have all the RAMcoolers in place, be sure they are pressed down firmly on the surface they are being attached to and lined up straight. Let the RAM stick sit untouched for about 15-30 minutes before moving on. Follow the same instructions for the RAM chips on the other side of the RAM stick (if this applies), and then let the finished RAM module sit for an hour or two to dry thoroughly. Reinstall it, and it's party time!

The finished product!

That's it! You have successfully installed a unique and beautiful cooling solution that will allow you to get the most out of your high performance machine!

If anyone needs any more help, has any questions, or any input on this matter, please send an email here.